Subject: Not list-related - Airboat ducts
From: ACRE
Date: 11/22/2004, 11:24 PM


George Lendich wrote:

A little off the topic here but when it comes to ducts, don't you
want to have as little clearance between the duct and the fan as
possible?
If that's the case, why would it not be preferable to have the duct built
as
part of the fan? In other words, the duct would just be a ring that is
part
of the fan. There must be a practical reason no one is doing it, because
it's so simple and there is no way that someone has not thought of this
first. So does anyone know?

Brian Trubee


 Marc de Piolenc wrote:

It's been done. Two words - skin friction.

Marc


Marc,
Could you offer just a little bit more info, for us chaps who ponder
these
possibilities.
George (down under)

-george wright wrote:

There have been a number of people who have looked at an integrated
fan/shroud.  I know I did for a few years.  A former Pratt & Whitney type
actually built one for use with a rotary engine!  One of the problems with
such a system is the load on the rotor hub.  This tends to lead to the use
of supports on both sides of the rotor structurally attached to the
aircraft, which kind of negates the point of the exercise.  I was looking at
a slightly different idea in which air passed through "stages" each stage a
slightly larger diameter than the previous stage with a suitable "bead" to
maintain attachment as it slightly expanded into the next stage.  I've never
built one of these gismos, but it might not be as bad in a buried design
where the frictional losses are confined to the inside of the duct and
rotor.

George you Marc are both now on here I am going to run this idea by you two
and see what you think.

This is a low speed inflatable lip to enhance low speed thrust by generating
a low pressure area over the surface of the lip.

The third jpg is intended to illustrate a way to keep the exit area ratio the same
while reducing the over all aerodynamic drag of the duct itself by mitigating
the outside departure angle.

Paul Lamar

Marc de Piolenc wrote:

The inflatable lip idea has been done - on a fan-in-wing job I think.
According to the guy who told me about it (I think it was Pazmany) it
worked - static thrust improved. I believe this, as I would expect any
increase in lip radius to be favorable under static conditions.

Marc

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.