Subject: Velocity of water through a 1.5 inch ID pipe.
From: ACRE
Date: 11/22/2004, 8:45 PM


"Kent, Russell" wrote:

Paul Lamar wrote:
Just for the heck of it I thought I would calculate
the velocity of the water going through a 1.5 inch pipe.

Is that 1.5 inch I.D. or O.D.?  I assume you mean I.D.

The area of the pipe is 1.77 square inches.

So far, so good.

A gallon is 235 cubic inches
Nope, it's 231 cubic inches.  Where are you getting these erroneous
numbers, Paul?

so the length of pipe needed to hold a gallon is
132 inches long or 11 feet.

Close: 130.7 inches, or 10 ft 11 inches.

At 50 GPM that means water is moving down the pipe at
550 feet per minute or 9 feet per second. 5 MPH.

A 50 GPM flow rate would be:
50 gals/minute * 130.7 inches/gal = 6,535 inches/minute = 6.2 mph

Russell Kent

Next time you can make the calculations :)

Paul Lamar


Head loss (pressure drop) calculations are not that difficult. Here are
the equations for those of you that do not mind a little math.
http://www.engineeringtoolbox.com/21_459.html  OR the rest of you will
have to make due with this table for estimates.
http://www.piping-toolbox.com/18_643.html

Alex Madsen

Thanks Alex.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.