Subject: Not list-related - Airboat ducts
From: ACRE
Date: 11/23/2004, 1:29 AM


George (down under) wrote:
I mentioned that [fan with duct attached to tips] to someone
( ducted long-ez , was it Perry?) some time ago, in a private
communication. The boat industry has been doing that for
years and the performance is much improved. I notice they
don't do it on the large boat props for the same reason it
might not be good for aircraft application - centrifugal forces
would
be
considerable on a duct ring - the bigger the ring the bigger the
forces.


"Kent, Russell" wrote:

The cold war era Russians used "shrouds" on the screws of some large
vessels.  Their mass manufacturing may have been crap, but their
scientists were top notch.  I believe this photo to be of a Type 941
Akula (NATO "Typhoon").

Russell Kent


That was an interesting picture - since it was a submarine, the purpose
may  very well have been noise. A tip shroud rotating can be handled
quite nicely with current marerials. On an early ducted fan at GE
we used a segmented tip shroud of titanium as a part of the labrynth
sealing of the stage. It did not use hoop, but was completely carried
by a pin and clevis configuration at the tip of the 17-4ph blades.
Carbon fiber in hoop can support a rather high centrifugal load.
Vance

Vance,
So are you saying that a rotating shroud - or integral prop and shrouds is
feasible for Light Aircraft, and that there are benefits to be gained in
this approach.
I respect your knowledge Vance, so if your saying this is a possibility, I
would find that very interesting !
George (down under)

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.