I am thinking of having the fuel rails made in a local machine shop.
They will definitely need measured drawings.   Jerry

Let me know if loading it into ACAD and using the ACAD dimensioning

facility

does not work. In any event you need to make a prototype to check the fit.

Do you have a Mazda fuel rail pressure regulator? If so loan it to the
machine shop so they can match the threads.

Have you decided on what you are going to use for fuel plumbing?
I recommend 3/8 minimum.  AN -6

Paul Lamar

Paul,
I would be interested to see how you attached the fuel rail to the inlet-air
Plenum.

George (down under)

Just weld on a couple of tabs. There is enough flat area of this type of 
fuel rail to drill retention holes. 

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.