Jerry Hey wrote:
I just read a very helpful article on building fuel rails and intake
plenums. Part one is general building. After that there are two
links. Link one, believe it or not, does a step by step complete
fabrication of a fuel injection system for the RX-7. It is very
similar to what we have been talking about. The injectors mount on the
plenum angled down. It may help with the Kiss. Rather than waste
words, go there and read it. Link two, describes building a similar
system for a Suburu that is intended for an airplane. Good
Stuff!!!! Jerry
http://www.sdsefi.com/techrail.htm
He is the guy I got the 1/2 inch square steel tube fuel rail idea from.
My KIS is cast in concrete with the cast aluminum air horn-injector holders.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.