Subject: Cool tube clearance
From: ACRE
Date: 11/26/2004, 8:29 AM


I think the cool tube will clear the mm beam if you
keep the muff can short and use two 3 inch center line radius
two inch dia. 45 degree bends.

Paul Lamar


How short?  right now we are using a 10 inch can centered on the
exhaust ports.  Jerry

OK the exhaust ports are about 5.25 center to center on the two rotor so 
that is 7.25 long adding 2 inches for the tubes. I think eight or eight and a 
half inches would do it for the 2 rotor muff can. You could do a cardboard mock up
and check.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.