François Badoux wrote:
Hi Paul,
Some news and data from Mistral which, I hope, will be of interest:
The G-190 is back on the bench as of this week. After less than 3 days, it is performing beyond expectations and is much less of a headache to tune than the turbo version. We still have much room
for improvement (for instance, we haven't yet started the lean-of-peak mode mapping or injection timing optimization) but already got the following figures in stable and repeatable power modes:
- 185 BHP max power, measured with the DIN norm (our target was 180 BHP). It is a few HP in excess (~194 BHP) of the 190 HP promised under the SAE norm. Prop RPM was 2,200.
- BSFC down to 0.47 lb/hp.hr. A very positive fact is that the minimum of the BSFC curve takes place between 140 and 150 BHP which corresponds to 75% cruise and climbs back up in a very shallow way
afterwards. Prop RPM was 1,870. At Oshkosh, we were already giving the same figure (although for the turbo model), but in lean-of-peak mode, while this latest number was measured still in
rich-of-peak mode! I am pretty sure we'll have yet a lower figure to communicate next week.
- EGT hovering between 1450 and 1550°F, hot but very acceptably so.
Testing is being done with medium-quality (probably comparable to US 87-octane) unleaded mogas.
The engine is very smooth and very responsive to throttle movements. It's a bit on the loud side though, as we made no effort so far to muffle it. Quite at the contrary, the test bench exhaust
system resonates pretty badly as we designed it for symmetry to prevent any imbalance between the 2 rotors, and not in any way for noise suppression. We'll tackle this challenge in a later phase.
We still have 2 weeks of work to finish up its "mapping" in the DEM system Gen II. We shall also test a new, simpler and lighter intake manifold.
I append a picture of our Arrow in flight, as well as a little video (for your own enjoyment as I know you cannot send videos to the newsletter readers).
Have a great weekend,
Francois
Thanks for the update and data Francois. It is greatly appreciated.
I'll send the movie to Bob White and see if he has room for it on his web site
for download.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.