<snip>
Brian, what size core are you using? Mine is 465 cu in. There is
plenty of evidence that done right a smaller radiator will work. I
think the 600 to 700 cu in numbers are simply too much to fit in the
average aircraft. People like Chuck and Ian have proven it can be
done without all that capacity. Ian flew all over the Outback, where
it really gets HOT, with only 400 cu in total volume in two heater
cores.
<snip>
I am looking at heater cores with increased interest because they offer
better coolant fllow through than evaporator cores. However I have not come
across a heater core that is 200 cu ft in volume. I assume that Ian uses
two heater cores. Can Ian, or anyone who is knowledgeable about his setup,
respond back with details on his cooling system setup including the type of
heater cores that he is using.
Thanks
Del Johnson
Ian is off the list. She who must be obeyed put her foot down after his engine
blew a cooling hose and he crashed. I don't need to nag you again about using
silicone hose and constant torque hose clamps do I?
I may have a few pictures of his cooling set up.
The facts are one can get a wide range of sizes of car radiators. Why would
one want to fool with anything else not designed to cool a car engine? Heat
(radiators) exchangers have many design features. Air flow porosity, air
passages designed for a specific ranges of air velocities and heat transfer
properties of air. Coolant tubes designed for a specific range
of coolant velocities (flow rates) and heat transfer characteristics of liquid
coolants. Why would one even think of using something else? One would not try
to fly a car, would one? I guess hope springs eternal that some heat exchanger
engineer somewhere screwed up? There is plenty of room for creativity in the
design of experimental aircraft without bucking the laws of physics head on.
For example; using a some chewing gum when high strength adhesive is called for.
One's goal is to build an airplane I think. I don't think it is to do R&D on heat
exchangers. If it is, one needs to read what has been done so far. In that case
I can recommend a book that is the culmination of 20 years work and 20 million dollars.
Namely Compact Heat Exchangers Third Edition by W.M. Kays and A.L. London.
ISBN 1-57524-060-2.
That is not to say that one, brilliant as one may be, may never discover
something that the heat exchanger engineering community has overlooked.
Just kidding.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.