Subject: Alcohol in fuel and composite tanks.
From: ACRE
Date: 11/30/2004, 6:19 PM


Doug,

I have attached a graph which I reproduced from a 1979 technical
report at my
company detailing the effect of ethanol content on a typical
nitrile compound
similar to what would be used in a fuel hose.  Note how it peaks at
20% in
this study.  This is typical of alcohol/fuel blends.  Notice that
at 95%
ethanol, the volume change is nearly the same as 100% ethanol.
That change
is less than half of what pure gasoline causes.

Charlie Smith
KIS Cruiser 4021


 Thanks Charlie

This news is promising.

Doug  in Japan

No reason the aluminum tanks should leak if they are well designed and
welded by somebody like Ed who has the ability to lay down a heavy,
fully filled bead.   They don't need to be sloshed.    Jerry

Old news; FWIW: Vans no longer recommends sloshing RV tanks.  They still
Proseal all the joints.  It's been awhile since I've read the Van's
newsletters, but I think I recall reading that slosh-filled fuel screens and
gascolators brought down more than one airplane.  I seem to recall similar
issues from Canardians.  One of the reasons for the move toward the Jeffco
products in fiberglass tanks, I think.
Andy


I'm sure that one could take the time to design individual alminium tanks to fit into the space between each rib, cut the patterns for the tanks and have them skillfully welded.  You could then install them with vibration isolation so they don't abrade through the glass during 50 years of flight and then plumb them together.  Or you could place two coats of Jeffco 9700FCR on properly abraded and cleaned fiberglass and forget about it.  No worries about ethanol corroding the Jeffco or leaks in the between tank connectors.  No issues with venting each compartment.  Neat and tidy just like the deisgner intended.  It's Doug's choice but if it were my plane and I intended to run either ethanol or Diesel fuel, I wouldn't give the Jeffco a second thought.  Grounding your filler caps is a much more important issue by comparison.

Doug, many of the US (and Japanese) auto people use fuel hose with fluoropolymer tube sections and epichlorohydrin covers.  Very robust in chemical resistance and more affordable than exotic high fluorine content specialty polymers.  May be worth checking out.

Charlie Smith
KIS Cruiser 4021

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.