Doug if I were you I would leave the R&D to Baylor and focus
on your goal. Use aluminum tanks. You have plenty on your plate.
Paul Lamar
Paul,
Yes I have taken your advice to heart and have looked into designing two 53
gal. tanks (one for each side) to replace the present 110 gal. wet wing.
That challenge is even greater and involves assuring the strength of the
wing is unaltered, as I would now have to make a good bond between the
aluminum tank with its internal ribs and the fiberglass skins. I would
still have to slosh the tanks or Proseal them. Hey if it isn't one thing
it
another. Nah... I'll wait a bit on this one and see if a solution :)
presents itself.
On a lighter note I am making progress on setting up the 13B to begin turbo
compound testing next month.
Doug in Japan
Doug,
If you are using 5/95 gasoline/ethanol, as memory serves me this mixture is
little more aggressive than pure ethanol. I'll see if I can dig up the old
charts showing the effect of blending ethanol with gasoline on standard NBR
fuel hose. Data are always convincing. Unless you plan to run 85/15
gasoline/ethanol mixtures, the Jeffco system should be plenty of protection.
It is what Bill Schertz and I have in our wet wings. The testing I did with
the 85/15 fuel blend (the most aggressive blend ratio) looked fine after
about one month of exposure. No cracks or crazing. Either fluid alone is
not that bad as far as exposure to polymers. There is something magic about
the 85/15 ratio that really tears up polymers. As far as my wings go,
unless I run gasahol, I'm not in the least concerned about leakage through
the Jeffco. Avgas and standard mogas do not present much of a problem with
Jeffco.
Building and then sealing aluminum tanks would be a real pain and may leak
more than your wet wing ever would. If you really want to go that route,
I'm fairly certain automotive fuel tanks are made from high density
polyethylene. Maybe somebody could mold a couple HDPE tanks for you or you
may find some existing HDPE tanks that could fit your wing geometry. I've
never looked so have no idea of what's available.
Good luck,
Charlie Smith
KIS Cruiser 4021
Doug,
I have attached a graph which I reproduced from a 1979 technical report at my
company detailing the effect of ethanol content on a typical nitrile compound
similar to what would be used in a fuel hose. Note how it peaks at 20% in
this study. This is typical of alcohol/fuel blends. Notice that at 95%
ethanol, the volume change is nearly the same as 100% ethanol. That change
is less than half of what pure gasoline causes.
Charlie Smith
KIS Cruiser 4021
Thanks Charlie
This news is promising.
Doug in Japan
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.