OK here it is for all you Russell Intake Manifold fans.
Looks very feasible indeed. The plenum would be mounted
at an angle and two fuel rails used. 3 inch dia cold air
tube comes straight in between the two tubes and the fuel rails.
Works well with cheek inlets.

Paul Lamar

I don't see the reason for the two fuel rails.  The airbox would be
about the same as in the cross over manifold, just setting at an angle.
About putting the fuel rail on the hot side,  I wonder if  a box that
enclosed the fuel rail and injectors  could be attached to the  plenum.
  There would be a drain to a safe overboard in the event of a problem.
It would be removable, of course, for service.   I wish I could form 2
" aluminum tubing.   Anybody know how?        Jerry

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.