Paul,
I am finally starting to get a handle on lofting with solidworks.
This is my first success for the RV-10. The shapes will change
and I plan a third low-center inlet for the muffler. Comments?
Bill Jepson

Solid Works has a steep learning curve. Cowls are tricky in any program.

Paul Lamar

Here are the secrets to lofting cowls Bill.
Start with this and experiment on longitudinal position of the lofting
lines and the radii.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.