George Lendich wrote:

"Kent, Russell" wrote:

Paul Lamar:

Looks like we can put a baggage compartment on the right side
of the engine. I have another idea for a simpler alternate air
valve. I think I can squeeze it in in front of the plenum.

OK, now I see why you have two fuel rails.  What about this idea?

Russell Kent

That will work but it is not as internally clean aerodynamically.

Paul Lamar

Paul and Russell,
Keep going you chaps, you've almost got it !!

A suggestion, there seems too many complex bends.

It might be better to minimize the bends to two 90 degree bends each tube.
I don't know if this will fit Paul - how about a 90 degree bend coming out
and bending forward, on each tube.

Both tubes turning up or down into a  horizontal plenum - preferably
injectors facing down.
The inlet tube coming from the front directly into the plenum ( same as
original plenum).
Will it fit ?
George ( down under)

I don't follow you. Can you do a 3D using stock bends? A sketch?
Both tubes have to be equal length. 20 to 23 inches long.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.