Jerry Hey wrote:
Paul, I share the enthusiasm for the Russell intake. However, Ed came
up with a good idea for the cross over intake that you should
consider. Simply put, cross the 180s by giving one a two inch longer
leg coming out of the engine. Doing so you can lay them down flat.
Then add the two inches back at the other end before the plenum.
Jerry
Hi Paul, perhaps Ed means the following:
Make the flywheel end tube the 'outside' tube, and the waterpump end tube the
"inside" tube. For crossover clearance, have the inside tube rise slightly as it
leaves the plenum, ( away from the hot muffler) and the outside tube fall slightly as
it leaves the plenum ( towards the cool air pipe) . The plenum could be canted
giving additional vertical separation for the tubes to cross over each other. Also
making the inside tube bend less than 90 deg and the outside tube bend more than 90
could help with length adjustments. In the attached jpeg, swap the tubes at the
plenum end. BR, Dave McC
Been there done that.
I'll believe it when I see a 3D Dave :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.