Jerry Hey wrote:

The two drawings Russ-final-TV-2D and Russ-final2-TV-2D appear to have
different lengths coming out of the engine.  Also, Russ2-18-inch-TV-3D
is different from the final2.  Concerning the rear runner,  how would
the 20 degree turn down be accomplished?   Thanks,  Jerry

I'll check everything later today. Just do the 18 inch version which
is closest to the engine. The 20 degree bend is cut down from a 45 or
a 90. You can probably do it by setting your friction blade chop saw
to the right angle.

Paul Lamar

Just weld up these tubes and it should all fit together.
Cut off the straight sections going into the engine as short as possible to 
to compensate for the length of your p-port TB's. Don't cut the holes
in your plenum until these tubes are mounted on the engine to get
the exact spacing.

BTW the Newsletter will be shut down tonight for a bout a week.
Don't send messages as they will fill my earthlink mail box and they maybe
lost forever.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.