In this implementation the second pipe is so short and fat it will be
> tuned to a RPM range out of a normal operation of the engine. A similar
> system is used in the RX8 motor except the second pipe is longer and tuned
> to the proper range. The RX8 injectors of course are someplace else.
>
> Since the tuned length of a runner is related to its diameter the smaller diameter
> pipe needs to be even shorter than 17-18 inches. My guess is a tuned length
> of about 15-16 inches is about right. The center line length of the 180 is
> about 7.8 inches. Add two inches where the pipe comes straight out of the
> port and you have 9.8 inches. Add 6.2 inches for a straight section and
> the plenum is right on top of the motor.
>
> Also a smaller diameter pipe has a somewhat smaller tuned range. (Higher Q)
> To broaden the HP RPM range the second 2" pipe can be about 19 inches or 15 inches
> depending on whether you want to move the HP curve up or down. shorter will
> give more power on the top end. Longer will broaden the curve downward.
> The peak power will suffer however.
>
> Good luck getting the mixture the same in front and rear rotor.
>
> Due to the smaller pipes the HP generated will not compare to the two
> inch Russell manifold. The area of a 1.5 inch pipe is about 1.76 square inches.
> The area of a two inch pipe will be about 3.14 square inches.
> The air velocity in the smaller pipe is almost double so the skin friction
> drag in the pipe will be four times higher roughly.
>
> You have enough meat in your P-ports to ultimately open them up to an area
> equivalent of a two inch pipe.
>
> Paul Lamar
BTW I thought the whole idea of the Russell was to get a low profile
for your manifold to fit under the cowl. I suggest you get or make a stock cowl
to be sure everything fits.
Paul Lamar
Jerry, I have never seen a system such as you have described. This doesn't
mean that it won't work, but there are several questions. First: Air in motion
doesn't act exactly as an electrical circuit and that causes several problems.
There are several efficiency losses caused by the transition into the varying
diameters. (result, lower max flow) Second: The location of the injectors in
the "plenum upwind" position here could be a significant problem. The into
the bellmouth injectors in F1 cars have a super short path, about 3-5 inches
with the ability to fire the injector when there is likely significant intake vacuum
to draw the mixture in. In the system you have drawn, the fat tube could
cause wave reversal (bounce back) at some RPMs which would make
tuning almost impossible.
Warning, anecdote: Several high RPM four cycles
that I have tuned ran into SEVERE areas of reversal where if you gradually
applied throttle the engine would actually stall at a certain RPM. If you
were wide open and rolled thru that RPM the engine would "catch" and
pull strongly to redline. The thing here is the single tube with bellmouth is
almost certain to work. If you have to run over-the-top then run as large
a diameter tube as you can and make it several inches longer. You may
and probably will lose a little over the "perfect" length but it will run well
and have a consistent vacuum signal. Tuning will be vastly easier and so
will fabrication. Rolfs layout may work well, but you will probably need to
inject close to the engine for tunability. I like the square plenum squirt
across system that we have been talking about. The need is to be able
to time the injection so you get the mixture sucked up, or you will be
buying yourself a great deal of trouble. Remember. I WANT YOU TO
SUCCEED HERE. Hang in there.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.