Jerry Hey wrote:
I.D./O.D........My throttle bodies are sized to match up to 2 inch O.D.
pipe which, if 16 gauge, is 1.875 I.D. The next size down is 1.75
O.D. which is 1.625 I.D. This size, inserted instead of butted, also
will match up with my throttle bodies .
The Chassis Shop (www.chassisshop.com) sells a mild steel combo bend
that has a 90 on one end and a 180 on the other. This one piece will
build 75 percent of the entire Russell intake. Short straight lengths
will complete the job. The price is $16.45. They will also do
custom bends for $20.00 ea. I bought a couple of 180s from them and
was surprised to find they were exactly bent and the legs were of equal
length. When you buy similar bends from Burn's Stainless that is not
the case. Jerry
You need 2 inch OD just to match the area of the stock four runner side port engine.
Forget 1.5 inch or even 1.75 inch. The lack of area will negate the P-port.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.