George Lendich wrote:
Paul Lamar
Paul, Rolf was answering my questions directly while ACRE was shut
down. He told me he very busy and is far behind on reading the ACRE
posts. I will forward your "invite" to him. Jerry
Here is some velocity and pipe skin friction drag numbers relative to a 2
inch
pipe ID. I assumed a 1.3L 2 stroke or 2.6L (158.6 ci) four stroke and 100%
vol. eff. at
7000 RPM and 310 CFM. CHECK MY ARITHMETIC. IT COULD BE WRONG.
Paul Lamar
Paul,
While is thread has been running I have been searching the internet for any
info I can find.
One thing I found interesting was someone mentioned (only briefly) the need
to maintain the velocity at or above 125 'per sec.
I had wanted to ask if anyone could put some credence to that assumption -
but didn't want to be a nuisance ( more than I have been on this subject).
Now you have supplied the info, I'm wondering if someone can support that
assumption or treat it as BS.
My thinking was if we can target the desired velocity, perhaps that can
point to the desired diameter. I'm not trying to disprove your diameter
decision or that of Mazda - merely trying to establish and confirm it
another way.
George ( down under)
It may be true for a piston engine. The history of the rotary is ever
increasing port sizes and HP. The third gen had larger ports than the 2nd gen and
the RX8 had 30% larger ports than the 3rd gen. Nobody anywhere has bettered
the NA HP of the Lemans engine at any RPM you want to choose from 6000 to 8500
RPM.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.