Matt Prather wrote:

I eyeball'ed this...  I can probably come up with something a little
more accurate should it be required.  Is this the format you were
looking for?

Regards,

Matt-

I have been working too hard lately what with all the variations
of 3D intake manifolds layouts I have been doing for Jerry.

I need somebody that knows how to do spread sheets to take the
two lowest dyno curves off this torque chart and convert them
to HP curves in gif or jpg format. This is the best torque
information we have on 13B geometry peripheral port engines.

The HP formula is torque times RPM divided by 5252 of course.

Paul Lamar

Almost perfect Matt.
I want to show how the HP falls off at higher RPMs  when the 175 MM is fixed.
Same goes for the 150 MM.

Here is a quick and dirty I did on 175 or 18 inches.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.