My question did not ask for max. power flow testing. Just testing

that

(in this case) both intake runners flow the same - as they do not

have

the same amount of turns, though they are the same length. If one
flows less than the other this one might run rich and/or the
"straighter" one lean. You might never find out, as the air metering
is before the air hits either runner. If you monitor EGT or have a
Oxygenesensor you also will see an average only......

Thomas J.

Matt Prather wrote:

Wouldn't it make sense to monitor the EGT's on each rotor seperately?

Matt

Probably, but it is quite a lot of instalation to find out that things don't
flow equal. But if you can hook up the injectors to be controled by each
sensor individually, it might work just fine. I have no idea if this would
be possible with a ny common controller in use.

Thomas J.

I think Tracy's system can handle that.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.