My question did not ask for max. power flow testing. Just testing that (in

this case) both intake runners flow the same - as they do not have the same
amount of turns, though they are the same length. If one flows less than the
other this one might run rich and/or the "straighter" one lean. You might
never find out, as the air metering is before the air hits either runner. If
you monitor EGT or have a Oxygenesensor you also will see an average
only......

Thomas J.

Thomas, put an egt in both exhausts. Or if you really
want to fine tune put a O2 sensor bung on both and use
onr of the standalone units produced by several people.
You can then just use a bolt to plug the hole.
Bill Jepson

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.