George Lendich wrote:

I have a pattern already for the second gen four port. Maybe I will

get a bunch cast up.

Paul Lamar

It is right in here where most people run into fabrications problems.
You can't just squash the pipe flat. The area becomes less than the

round

part of the pipe.

Yes the intake manifold flange is not shown.

Paul Lamar

I was kind of curious what a straight manifold would look like. Not likely
to fit in the average Long EZ. Might fit in the wing of a twin with

partially

buried engines. The firewall is only 24 inches in diameter. No cooling

rads or

muffler.

Paul Lamar

Paul,
That certainly solves the problem of the fuel too close to the exhaust and
the inlet is in good flow air, as well!
What about drag ?
George (down under)

You never really know until you try it. Might work on a reno racer.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.