Subject: D. Leonard's Turbo at 14,000 density altitude
From: ACRE
Date: 12/20/2004, 11:40 PM


Paul:

Dave's stock turbo was operating under the following
temperature conditions at or near the time of failure.  The
operating conditions are from memory and may not be exactly as
Dave described....but
close.

Altitude:  14,000 feet density altitude
Underhood temperature:  100 deg F (under cowl heated air into
the intake filter)
Turbo inlet pressure 7.5 psi (15" Hg)
Turbo outlet pressure 18 psi (36" Hg) Note: the MAP will be
2-4" less due to losses
MAP: 16.5 psi (33" Hg)
Compressor efficiency 70%  (This is probably higher than the
compressor was providing)
Outlet temperature of the turbo:  431 deg F
Pressure ratio 3.4

With these input conditions to the intercooler...
Intercooler input temperature:  431
Intercooler efficiency:  80%
Intercooler pressure loss:  1 psi (2" Hg)
Ambient temperature:  32 deg F
Intake manifold temperature post intercooler:  112 deg F

112 deg F intake air instead of 431 deg F intake air!!  It
isn't a matter of weighing the weight of the intercooler system
against some weight bogey....it is realizing that at any decent altitude,
the intercooler is a necessity on a turbo system.

Calculated using the neat on-line calculator at:
http://www.stealth316.com/2-turbotemp.htm

This is a good example of why an intercooler is an absolute necessity for
aviation use.  The conclusion reached is that intake heat and detonation did
not kill the Hummer which it might have without
the intercooler??  Dave was aware of this possibility and had integrated
his intercooler into his system in what I consider a very "sanitary" manner
utilizing his cowl inlet openings to feed the
intercooler and routing the intake tubing below the PSRU around to the
opposite side to the throttle body.

Doug Dempsey

Doug, I am pretty sure you are not putting the right numbers into the
calculator, as those numbers just are not right.  There is no way that my
compressor outlet temp is 431 deg, and the P/R should be much lower than
that.  My guess is that you are entering an absolute manifold pressure when
it is looking for a "boost" pressure.  Try using the attached calculator
instead.  I modified it to use an absolute manifold pressure.  I have also
loaded it with the initial conditions at time of turbo demise: 12500MSL,
under cowl temps only about 80F, 32.5 MAP, 6300RPM, measured intake temp 130
(oh and traveling at 189KTAS :-)

This give a more realistic temp drop across the intercooler of 110F and a
P/R of 2.01

Dave Leonard

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.