I think I have that version unless you made revisions in the last few

years.

Here also is some output data you sent awhile back.
BTW if anybody needs QB let me know. Runs fine on Windows XP in command

mode.

Paul Lamar

Yes - that looks like the same program, and to respond to other comments
it
is NOT
taken from Marty Hollman's book (thank you Paul for your input on that) I
have not
tried Marty's program, but I am pretty sure you cannot describe a prop
and
get
an output for mapping perf over a range of rpm and forward speeds.
Incidently
the case you chose for an example seems to show that it can predict
really
off
range. The program properly predicted if you had 50 inch pitch flying at
200 mph the prop would be acting like a wind generator at anything less
than
3400 rpm. For starting to set prop size the program PRPSIZ2 (which I may
have sent you before) is a good place to start. You give it hp and rpm
with
an honestly expected top speed, and it will suggest pitch and blade area
distribution for the selected diameter. (copy attached) _

I think Paul Lipps uses the Marty program, fine tuned to his case, and
with much
more
numerous and close spaced stri elements. But I do not think it is varied
very
far each side of design point
Vance

Paul Lamar

-Ed Klepeis wrote:

Dear Paul
       If Marty Hollmans prop designs fly like his so called super rotor
craft blades  I would caution the buyer be ward.
                                                                         Regards
                                                                           Ed

Not good results eh?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.