Subject: Finally oil formulted for the rotary.
From: ACRE
Date: 12/25/2004, 9:40 PM


There was an ad in RX Tuner magazine this month by the
company that supplied the synthetic oil used in the Lemans engine
to win Lemans.

Regular motor oil has a lot of additives that the rotary does not
need. These additives just gum up the rotors and the apex seal slots.

The companies web site is http://www.idemitsu-usa.com
They also published an SAE 922375 paper on the subject.
It uses polybutene as the base stock I think.

I am ordering a case  tomorrow and will replace the oil in the RX8 engine.
They also have pre mix apex seal oil for the fuel.

Paul Lamar

Here is the results of a test Idemitsu ran on engine oils from SAE 922375.
DI is an anti wear additive. This test is similar to the one we ran on oils 
a few years ago with similar results. We cooked the oil for 30 minutes at 500 F 
and they cooked the oil for 10 hours at 280 C or 536 F. Polyolester is turbine 
oil I think.

The viscosity rating is a pour test where the volume of oil poured
in unit time is measured.

BTW according to this paper main and rotor bearings start to fail at 150 C or 
302 F. Apex seals run at  240 C to 280 C or 464 F or 536 F.

Very very important to get the right oil to lube your apex seals.
 
Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.