Subject: Finally oil formulated for the rotary.
From: ACRE
Date: 12/26/2004, 9:13 PM


           There was an ad in RX Tuner magazine this month by the
          company that supplied the synthetic oil used in the Lemans
engine
          to win Lemans.

          Regular motor oil has a lot of additives that the rotary does
not
          need. These additives just gum up the rotors and the apex seal
slots.

          The companies web site is http://www.idemitsu-usa.com
          They also published an SAE 922375 paper on the subject.
          It uses polybutene as the base stock I think.

          I am ordering a case tomorrow and will replace the oil in the
RX8 engine.
          They also have pre mix apex seal oil for the fuel.

          Paul Lamar

     Here is the results of a test Idemitsu ran on engine oils from SAE
922375.
     DI is an anti wear additive. This test is similar to the one we ran
on oils
     a few years ago with similar results. We cooked the oil for 30
minutes at 500 F
     and they cooked the oil for 10 hours at 280 C or 536 F. Polyolester
is turbine
     oil I think.

     The viscosity rating is a pour test where the volume of oil poured
     in unit time is measured.

     BTW according to this paper main and rotor bearings start to fail at
150 C or
     302 F. Apex seals run at 240 C to 280 C or 464 F or 536 F.

     Very very important to get the right oil to lube your apex seals.

     Paul Lamar

Brian Sieber wrote:

Mike at Idemitsu (Apollo America) sent me case a couple of months back. I
should have my 13BT back together in the next couple of weeks and I'll be
running their lubes. I'll let you know what I can.

Brian

Brian Sieber
President/Art Director
RX Tuner Magazine
brian@rxtuner.com
904.525.7371

I think the Mazda dealers should be forced to use this oil in the rotaries.
When I took my RX8 into Santa Monica Mazda for the 15,000 mile service they
put cheap motor oil in it bought in 55 gallon drums I am sure. I requested
Mobile One but they said no. Now I have to suck it out and replace it with
the good stuff. Corvettes come with and use Mobile One.

Paul Lamar

Paul,

  What's your goal when choosing engine oil for your RX8?  Do you recommend
the same produce be used in aircraft rotary applications?  Why do you use
Mobil 1?  What do you expect to happen when you switch to Idemitsu?

Andy Hecker
ahecker@satx.rr.com

My goal is to find an oil specifically formulated for the needs of the rotary.

Yes. 

I used Mobile One (until Idemitsu) because it came out best in our heat test of oils 
and it is made by a large company with the resources needed to test it under all 
conditions. I can also buy it at Walmart in case lots. 

Less carbonaceous deposits in the apex seal grooves and on the rotors.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.