Ed Klepeis wrote:

Dear Paul
      I have been looking at a cone type  air filter that K&N says will flow 528cufpm will that be enough vol. I asked K&N for a  to see what a stock filter flowed they could not give me an answer.
They did say for the size of the eng that size filter/vol was enough what is your take on this subject.
                                                                                                                                                                Regards
                                                                                                                                                                   Ed
                                                                                                                                                        techwelding@comcast.net

It sounds fine for a ground test engine. When you get the engine
running we will measure the pressure drop across the filter with the
engine at full chat. Are you building a dyno? I hope :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.