Perry Mick wrote:

OK, I think I got it. Let me know if you see any problems. I will
replace the upper 1/8 x 1 x 1 aluminum extrusions with square steel
tubing with an endplate welded on and a hole drilled in the center
for a
bolt.

Perry

Yep. That looks like it. Have your son make a 1/4 scale  balsa model
to verify.

Paul Lamar

Ops just saw a problem. Can of worms. The model would show this quick.

Here is a simpler fix. Rubber rod ends. Still the one! :)

Paul Lamar

Paul,  I am following the evolution of this motor mount.  Should I hold
off for awhile in building the Turbo LEZ engine mount  until  the
design  is finalized?  This looks pretty good to me so long as
establishing a hard point on the firewall is doable.        Thanks,
Jerry

It is not much different than the Long EZ mount we did for a couple of others.
Which design are you thinking of replacing with this one.
 
Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.