Subject: Combo TB alt air and ram air
From: ACRE
Date: 1/3/2005, 6:30 PM


     Yes in theory they would include the bell mouths. I was thinking of adding
     two very large diameter small section ball bearings using Torlon balls.

     Paul Lamar

If that is the bearing set-up then you need a counterbore in the
large diameter tube so the inside tube can be close to prevent
leakage.
Bill Jepson

A little bit of leakage wont hurt. Just affects the idle.
Don't want to make it too expensive. Since I will make the
bearing the inner race is the OD of the sleeve and the outer
race is an internal slot in the outer housing. I just need to
figure out how to locate the sleeve axially. Still a work
in progress. I also need to take a look at Russell's ideas.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.