Subject: relocation of dip stick and oil fill tune
From: ACRE
Date: 1/6/2005, 2:59 AM


Ed Klepeis wrote:

Dear Paul
     Is there any place you could relocate the oil dip stick and oil fill
tube that would work so you could free up the area where it use to be
located. Also the section where these items are
located what is that mat. cast iron, cast steel, etc. could that mat be
welded onto or drilled and tapped without hurting any seal or gasket area.

Regards

Ed

techwelding@comcast.net

Come stright out the side of the pan with a half inch steel tube in the
deepest
area and then up at 90 degrees. If you are not using the crank angle sensor
that is a good oil filler spot. If you are make the new dip stick tube 3/4 of
an inch
in diamter.

Paul Lamar

If he is making an entirely new filler, why don't attach the dipstick probe
through the center of the filler cap. Some marine transmissions have this
feature: Dipstick/filler cap.
Bulent


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.