Subject: P port fuel injection mechanical
From: ACRE
Date: 1/8/2005, 11:32 PM


Alan Tolle wrote:

Paul, occasionally a question comes up which I think I should respond
to,
since I know more about it than anyone else.

Powersport under Everett Hatch used a clone of the Bendix manifold
pressure
controlled mechanical fuel injection system that was created by Don
Rivera
at Air Flow Performance specifically for him --- the same fuel injection
system that has flown millions of hours on Lycoming engines.  The
modification was separation of the air pressure measuring system from
the
fuel metering system, the former being incorporated as the air intake of
the plenum, the latter being linked to the throttle plates.

Injectors were one per cylinder just like everything out there flying
with
fuel injection.  Injectors were at first screwed simply into the oil
injection ports, later were positioned in the intake runner bend so that
they pointed directly at the throttle plates.   The latter worked very
well.  And as you remember the positioning of the throttle plates right
at
the trochoid housing completely solved the problem of idle roughness at
low
engine rpm.

Some might object to the injectors being on the hot side of the engine,
but
if you shroud the exhaust system in  a stainless steel heat shield as
you
should there is no problem.

You are aware that we spent a lot of hours on the dyno tuning the
intakes,
varying both length and diameter.  The result was 20% more horsepower
more
or less free --- and much less complicated that a turbo.  > > Alan
Tolle.


Alan,
I read your e-mail with much interest and would like to thank you for that
information - it all helps!

I do however have a question that has been niggling me for some time and the
answer hasn't been crystal clear to me. The question is- is it the butterfly
close to the port that fixes the rough idle or the injectors close to the
port OR BOTH.

I'm wondering if we take the injectors to the other end, do we sacrifice
idle at the expense of better atomisation and BSFC.

In other words is it the butterfly alone at the 'coal face' that fixes the
idle.

Another question Alan, what size  diameter pipes did power sport use in
their inlet manifold

George ( down under)


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.