Subject: Oil injection in the fuel
From: ACRE
Date: 1/9/2005, 12:19 PM


That is a new theory Ron. Conventional wisdom has it the motor oil
is
breaking
down at the 500 degree F the apex seal operates at WOT. Take another
look
at the chart I just uploaded. 260 C is 500 F. Here is the chart yet
again.

My test on motor oil where I cooked it in the oven for 1/2 hour and
Idemitsu's
test confirmed this fact. The other data is we have at least a 1000
hours on
an engine in aircraft service with mixed 2 cycle oil and the rotors
and
slots
are slick as a whistle. If you would like to confirm this test it is
easy to do.
Put one teaspoon of oil in a used cat food can and set your oven for
500
F.

Don't take my word for it :)

BTW Mazdatrix now carries Idemitsu oil specifically designed for use
in the rotary. I picked up a case of 10W-30 and replaced the garbage
the dealer put in my RX8 when I got the 15,000 mile service.

Paul Lamar


It just occurred to me that not everyone on here has seen the inside
of a used rotary engine. It is a wonder the seals don't stick long
before
they
actually do. The major two day job overhauling a rotary is cleaning
the
rotors.
Every body has their own way of doing it and just about every chemical
has been tried. Some will eat the rotor bearings. Here is a picture of
a couple of typical rotors. Here too is the temp distribution on
the face of the rotor. 200 C is about 372 F well above the coking
temperature
of most motor oils.

Paul Lamar


Paul,

Like I said, I'm probably wrong, but I started wondering about this
because
in taking apart an engine with less than 50,000 miles I was amazed at
how
thick the carbon buildup was.
I happened to know this car was driven mostly in rush hour back and
forth to
work with lots of starts and stops.
Another engine I dismantled was owned by a salesperson who was on the
road
alot ,mostly freeways. This motor had relativly very little carbon at
130,000 miles. If it had not suffered the classic O-ring water jacket
crack
in the center housing, it would have made it well over 200k, I'm sure.
Maybe as simple as just a good vs cheap oil. I don't know.
I haven't tested any motor oils but many baked/cooked on things are
cleaned
off by raising the temp. I don't think I'm ready to try a torch on my
rotors
though. ;-)

Ron Freier

If one engine used synthetic oil and the other ordinary motor oil that
would
account for the difference. Mobile One came out tops in my test except for
$10
a quart turbine oil. However Mobile One is not optimized for the rotary
so I have high regard for Idemitsu which is.

Paul Lamar

In gas turbines, coking problems are normally associated with heat soak back
into stationary oil after shut down or really excessive temps in a slow
flowing tube. A car driven short distances gives plenty of heat soak back
after shut down oportunities.

Mobil recently withdrew it's top HTS (High thermal stability) Turbine oil
(MJO 291) from market due to coking and attacking seals. Oil stability
testing is no where near as simple as to put a teaspoon full in a cat food
can and bake it..... or maybe this was just the one critical test that
ExxonMobil missed :)

Mark Wrathall

It is quick and dirty but it separates the men from the boys real well.
Try it you might like it :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.