Subject: New comer in rotary world and 1st question
From: ACRE
Date: 1/10/2005, 8:04 PM


The pump drive shaft design would be a relative night mare
compared to picking an existing shaft and encorporating the apex oil pump
on that shaft. Keep it simple.

Paul Lamar


Paul, I was under the impression that the pumps used by mazda are
the Mikuni pumps. I may be  incorrect there. If the standard pump
could be used it would be as simple as replaceing the pump and
using a different reservoir  or drawing from the sump.  The mikuni
pump can be used RPM only, (without throttle attachment), which
is probably OK for the rotary.
Bill Jepson

I think the early units were Mikuni. Ever since the 3rd gent they are
stepper motor control and gravity feed. Not fed from the oil pressure gallery.
That means if you are upside down or negative G's they don't feed.

A small gear pump will suck oil so a flop tube in an aux tank will
work for negative G's. Or you can suck it out of the pan if you insist
on using crankcase oil to lube the apex seals. In that case I highly
recommend Idemitsu rotary engine oil.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.