Subject: P port fuel injection mechanical
From: ACRE
Date: 1/11/2005, 5:21 PM


Final note.  In the five hundred hours plus that I  flew the Bendix
fuel
injection on the rotary engine not once, emphasis not once, did I
have a
start problem, hot, cold, or otherwise.  I can not say the same for my
experience with Bendix FI on Lycoming engines, but as we all know
Rotaries
and Lycomings are apples and oranges.

Alan Tolle.


Hi Alan, I think I talked to you a few years ago at Arlington? You told
me you had more rotary hours than I did. At that time it was true, but I
think I've nearly caught up to you!

Perry
500 hours direct-drive ducted fan
7 hours with planetary psru

Alan Tolle wrote:

Perry,

I have followed your work with the ducted fan over the years and must
commend you highly for what you have done.  Your efforts have given the
word "experimental" some real meaning.  However, I am  personally more
comfortable with the path on which you now find yourself since we know a
lot more about propellers than we know about fans.

The performance which you describe now seems typical of Long Eze experience
with props.  Three options are available for any wood prop installation ---
climb, cruise, or a compromise.  Twenty five years ago Dick VanGrunsven
strongly recommended only climb props, because that is what the RV-3 did
best, namely short take off,  rapid climb to acrobatic altitude, and quick
back to a short field landing.  Burt Rutan, on the other hand, considered
the Vary and the Long to be high speed cross country traveling machines
from one long runway to another so the recommendation was more in the
direction of cruise prop, which is going to show poor initial acceleration
and climb.   The loss of take off performance when a cruise prop is
installed on an RV is less noticeable due to the high lift wing being
optimized for that part of the flight envelope.  Since the Eze's wing is
optimized for cruise the doggy take off is hard to miss, but you can live
with it.

That I ended up with only 500 or so hours flying the rotary engine was not
really my intention.  For two years after Everett Hatch's death I left the
RV-3 configured for the rotary installation.  When Steve Beckham gave Power
Sport to Ray Richardson I spoke with Ray several times about what plans
Everett had for the future, and even offered to build and RV-6A and install
the engine which had just been finished in Everett's shop.   Unfortunately,
Ray wanted to keep things closer to home and ended up choosing people to
run his program who were a bit shy in knowledge of both the engine and
homebuilding.  The rest is history.

Actually Powersport is still viable, I suppose, but to be really successful
the company would have to back up a ways.  That would mean a lot of money
down the drain, a point which no one really wants to concede.

Anyway, good luck with the planetary gears.

Alan Tolle

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.