The regulators shunted un-needed current to a load.
failures were ALWAYS in a SHORTED condition.
wich fried the windings/wiring.
as all with suzuki's GT250 (74) gs-750 (78) and
gv1400gdg (86)
Stick with what works.
Louis
Louis,
I worked for Kawasaki which used a permanent magnet alternator
900 ZI '73-about '83 with fewer problems than their field and stator
systems. They did NOT short to ground or load, that is old zenier diode
stuff like the brits used in the 50's! The system opened the "Y" winding
to cut power. This was one of the most reliable systems I ever worked
with. The advantage is that the system will generate power any time
the engine is running. The disadvantage is the weight of the system,
most weighed 7-8 pounds which is quite heavy especially for a back-
up system. Lastly, the permanent magnet alternator drew more power
when operating by a small percentage. I am not an EE but it was
explained to me that there was some "field quenching losses" when
the sine wave passed through the windings. I sure there was waste
heat generated there as well. I NEVER saw an electrical fire on any
of these machines.
Bill Jepson
Bill,
Yes you are correct. Even the last three years there have been some
amazing breakthroughs in PM generators and even more so in control systems.
Shown below is our companies' latest PM true 3 phase wind gen. rated at 1KW
at 1270 rpms. Blades are carbon fiber. Tail wags to keep it aligned.
Aluminum body with no bolts.
Playing with it we have let it rev up in strong winds to over its design
limits to 2500 rpm where it started slipping but still put out 3K. Up to
500 rpms it sucks as a generator:)
IMHO for an in the bellhousing, direct connect motor/generator, a large
diameter unit would work best. Pancake motor or magnets around the
circumferance. At this point in time 3Kw is about the best weight, cost
performance, and versatility for this concept. Probably the most efficient
and simple turbocompounding system will still be direct gear.
Doug in Japan
That sure is cool looking Doug. It has very Japanese looking style to it.
Looks like you could make your own props. What are they made out of?
You need a larger spinner. You are getting energy absorbing vortexes
off the roots of the blades.
What do people use a 1 Kw 3 phase wind generator for?
3 Kw (4 HP) pancake motor in the bell housing? What is that for? Starter
generator perhaps? What would it weigh?
Paul Lamar.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.