Subject: some Honda IMA motor/gen specs (so much for that idea)
From: ACRE
Date: 1/24/2005, 8:00 AM


FYI,

this is from the automobiles.honda.com website.

ENGINEERING: ELECTRIC MOTOR / GENERATOR
INSIGHT
Permanent Magnet Motor Standard

Horsepower @ rpm (SAE net)     14 @ 3000   13 @ 2000

Motor Width (mm)   60

The "fly in the ointment" may be that the IMA appears to be a 144
volt system
!

Keep after that "pancake" starter/generator project !!!

(so much for that idea)
Thanks,
Tom

Tom,

We are thinking alike.  These types of motors were the first thing I
looked
at also. Besides the high voltage and hp, the weight is a killer.  I
like
the idea keeping the engine as slim as possible and hence one location
for
the starter/alternator is in the bell housing.

The company Marc introduced, with the alternator on the water pump
could be
the second location. Made by Barrett Racing I believe.  I checked the
website again and found that some units deliver up to 32 amps which
might be
fine for a back-up.

BTW thanks Marc. for finding that item.  I would be interested in the
alternator only and making an adaptor to fit the RE inhousing water
pump.

Doug in Japan

-Marc Wiese wrote:

Doug,
Racemate may be interested in casting a low profile water
pump/alternator for the rotary. Especially for the FD 3 gen engines I
work on (and 20B), the pump profile and inlets and outlets, etc are too
big and convoluted. A more compact design should be easily obtained,
perhaps using a stock sort of widely available pump body that is easily
replaceable.
We are only looking for secondary back up power here, besides the
batteries, wind generator?, stock alternator and another back up
battery, etc, etc.

"Inlets and outlets too big?" How do you propose getting 35 gal per minute
through smaller inlets and outlets. Repeal the laws of physics? :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.