Subject: Large axial flow turbine for TC experiements
From: ACRE
Date: 2/2/2005, 7:01 PM

Matt Prather wrote:


Mark Wrathall wrote:

Sorry to send while you are leaving Paul, but I just found this
site.

http://jetbeetle.com

The guy is selling quite large Inconel turbines.

Mark


Wow! Cool! Another turbine we can use for experimental turbo
compound engines.

It would be a waste to use this on a ultralight. A couple of these
on a very small single place all carbon fiber airplanes would make
a great toy. You won't travel far.

300 pounds of thrust at 350 MPH is 280 HP. If the gross weight is
1500 pounds the initial acceleration is .2 G or 6.4 fps per fps.

A short QB program yields the following take off chart. On the
ground only. No rotation. A rotation will slow the aircraft.

Check my calculations here as I have been known to make mistakes.

Paul Lamar

I forgot the landing gear was down so the drag would be much higher
on the ground. To be conservative I changed the Flat Plate drag to
1.

What happens when you rotate is the induced drag due to lift becomes
a major factor so you need to get the gear up as soon as possible.
This is a small wing area design. Say about 50 square feet.
1500/50 is a wing loading of 30 pounds per square foot.
At a C sub L of one means minimum take off speed and stall will be
around 110 MPH. You want to keep it on the ground well beyond that.

I would not try to fly something like this in less than a
3500 foot runway.

If you can get the flat plate drag down to .3 or so top speed should
be close to about 450 to 500 MPH or more. Assuming of course he
achieves the thrust he thinks he will.

Paul Lamar

I am imagining a BD5 with a pair of them mounted on pylons, ala a
Lear23 or like an early Citation.

Regards,

Matt-

That would be fun. then you have room in the fuse for fuel. You will
need it :)

Paul Lamar

Actually, the more I think about this, the more I like it..  The original
BD5J
engine produced about 200lbs and has since been updated to about 300lbs.

With these engines, taxi with only one lit, takeoff and climb with both of
them
going, then shut down one for cruise.  Re-light the extra engine while
entering
the landing pattern to be prepared for a go-around.

I think this is good because (call me crazy) I don't have perfect confidence
in an airplane powered by a single Taiwanese hobby engine.  Especially if
the airplane is a hot rock.

Then again, I just ran the fuel numbers...  Woo.  33gph flat out.  26gph at
80% which is probably about where you would want to run ONE of them.
I was hoping for 400mi range, but 250mi might be pushing it.  Would standard
lapse rate reduce power output (and fuel flow) just like a normal ICE?  If
I fly at 16k' will I be down around 50% power (and fuel flow).  I might be
able
to live with that.  I think the BD5J standard tanks are 36gal.

This is fun...  :)

Matt-

VE N34RD, C150 N714BK

The next think you will need is an ejection seat :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.