Mark Wrathall wrote:
Sorry to send while you are leaving Paul, but I just found this
site.
http://jetbeetle.com
The guy is selling quite large Inconel turbines.
Mark
Wow! Cool! Another turbine we can use for experimental turbo compound
engines.
It would be a waste to use this on a ultralight. A couple of these on
a very small single place all carbon fiber airplanes would make a
great toy. You won't travel far.
300 pounds of thrust at 350 MPH is 280 HP. If the gross weight is 1500
pounds the initial acceleration is .2 G or 6.4 fps per fps.
A short QB program yields the following take off chart. On the ground
only. No rotation. A rotation will slow the aircraft.
Check my calculations here as I have been known to make mistakes.
Paul Lamar
I forgot the landing gear was down so the drag would be much higher on
the ground. To be conservative I changed the Flat Plate drag to 1.
What happens when you rotate is the induced drag due to lift becomes a
major factor so you need to get the gear up as soon as possible.
This is a small wing area design. Say about 50 square feet.
1500/50 is a wing loading of 30 pounds per square foot.
At a C sub L of one means minimum take off speed and stall will be
around 110 MPH. You want to keep it on the ground well beyond that.
I would not try to fly something like this in less than a
3500 foot runway.
If you can get the flat plate drag down to .3 or so top speed should be
close to about 450 to 500 MPH or more. Assuming of course he achieves
the thrust he thinks he will.
Paul Lamar
I am imagining a BD5 with a pair of them mounted on pylons, ala a
Lear23 or like an early Citation.
Regards,
Matt-
That would be fun. then you have room in the fuse for fuel. You will need it :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.