Subject: Large axial flow turbine for TC experiements
From: ACRE
Date: 2/13/2005, 5:39 PM


Mark Wrathall wrote:

Sorry to send while you are leaving Paul, but I just found this site.

http://jetbeetle.com

The guy is selling quite large Inconel turbines.

Mark

Wow! Cool! Another turbine we can use for experimental turbo compound
engines.

It would be a waste to use this on a ultralight. A couple of these
on a very small single place all carbon fiber airplanes would make a great
toy. You won't travel far.

300 pounds of thrust at 350 MPH is 280 HP.  If the gross weight is
1500 pounds the initial acceleration is .2 G or 6.4 fps per fps.

A short QB program yields the following take off chart. On the ground
only.
No rotation. A rotation will slow the aircraft.

Check my calculations here as I have been known to make mistakes.

Paul Lamar


Mark wrote:
The BD 5J only had 200lb thrust, but I wouldn't bet much on flying a jet
beetle engine. Has just scaled up the most common model turbine design, but
this design is only good for a hour or two of operation, ten max. For a
model this is about 100 flights so it doesn't matter, but for a homebuilt
this won't even get you far inot the test flight program.

Regards,
Mark


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.