"Echo Lake Fishing Resort (Georges Boucher)" wrote:

 Hi! I'm a new subscriber and have a couple of questions. I'm building a STOL Christavia Mk IV on floats (2200lbs gross) using a 1991 13b NA 6 port Mazda engine with RWS's 2.85:1 PSRU as well as
there EC2 EFI/Ignition & EM2 Monitor. I'm considering a 2 blade 84" Ivopro Prop or a Warp Drive 72" 4 blade . Here are my questions, I want 200 to 220 hp ( I also want reliability, not a hand
grenade), what kind of porting should I do street port? P-ports? where can I get templates, I was told Mazdatrix but couldn't find templates on there site. Second I have 38 years  experience as a
mechanic but never had anything to do with rotaries, please critic the above combination any suggestions would be appreciated.
Regards.

Georges & Gail Boucher
2126 Creighton Valley Road
Lumby, British Columbia
Canada  V0E 2G1
(250) 547-6434
www.echolakefishingresort.com
www.echolakefishingresort.ca

Well for over 200 HP you will need a p-port or a turbo charger.
A p-port is cheaper, weighs less and is more reliable than a turbo.
A Christavia on floats is unlikely to cruise long distances at 14,000 feet
where a turbo charger would pay off big time.

The basic 2 rotor engine is structurally good for 800 HP.

A Warp drive would probably work but a wood prop might be slightly more
efficient. Large diameter is good for low speed thrust but 84 inch might limit the 
RPM and therefore the HP. You want to shoot for about 7500 RPM for takeoff. 
My guess for a first cut is keep the prop diameter down to about 76 inches. 
Best to use a variable pitch prop with sea planes. An IVO prop is variable
twist which is not what you need. Also Ken Welter has extensively used NOS 
in his 3000 pound Coot to get it off the water. 

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.