Steve Thomas wrote:

Hello ACRE,

  I've been looking at Ed Klepies heater core and fan (nice piece of
  equipment) and was wondering what everyone is using for a heater
  control valve?  Most of the automotive units are vacuum controlled
  and I was wondering if there is a manual valve or an electrically
  controlled valve that someone has found to work well?

  Also, for those who have purchased Ed's heater core, what are you
  using for a plenum?

--
Best regards,
 Steve Thomas

Ed Klepeis wrote:

Dear Steve
       The temp is controled by a 3position switch off-low-med-high which is
supplied with the heater.
                                                                         Regards
                                                                   Ed
Klepeis
                                               techwelding@comcast.net-- 

Ed, will you be at Sun & Fun with your engine on a trailer?
I need to get that set up.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.