Subject: IVO props & Sea Wind landing gear retraction
From: ACRE
Date: 2/15/2005, 9:39 PM


Paul

Welcome back.

I contacted IVO props recently to get some info on their specs. for the
twisting props.  A three blade paddle prop like the ones used on Russian
amphib. would weigh about 30 lbs. I asked them how to be sure all of the
props are at the same 'pitch'.  I am still waiting for the answer.

As I understand it the IVO props' outer portion of the blade twists while in
a commonly configured variable pitch prop, the whole blade revolves around
its longitudinal axis. Intuitively it seems the IVO props seemed to be a
compromise in efficiency as  only a small percent of the total blade is
creating greater lift. I am not actually sure of this reasoning though.
Could anyone explain it better?

Another question.  I am working on the landing gear design now. Do you have
any idea how much the steering drive motor and linkage weigh on the RX-8?

Doug in Japan

No idea on the weight of the RX8 steering gear. I guess it is unlikely
your local dealer would have one in stock. Surely there must be a few crashed
RX8's in Japan by now. The rack and steel tie rods 50 inches long and
.8 inches in diameter would be about 7.5 pounds. Not counting the motor or 
housing. If the aluminum housings were 3 inches in diameter with a .1 wall and 30
inches long it would weigh about 2.8 pounds. Again not counting the motor.
As a wild ass guess the whole thing would be about 17 pounds plus or minus 
3 pounds.

Paul Lamar 

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.