This can be made with just a sheet metal shear and a brake.
The slide uses six small off the shelf ball bearings and shoulder
bolts from Stock Drive Products. Can be made from steel or aluminum.
The slide will work best when made from .065 steel as it is stiffer
than aluminum. The inner and outer sheet metal parts can then be made from
.065 T3 aluminum sheet.
My guess this is worth 10 to 15 HP more over using
butterflies with P-ports.
If anybody is interested I will do a 2D dwg with dimensions.
Paul Lamar
Joseph M Berki wrote:
Paul,
Were you planning on using the Racing Beat P port housings? What
diameter are the ports? Nice job on the dual sliding throttles.
Joe Berki
Limo EZ--
When I get my dyno engine running, hopefully later this year, it will be
a turbo charged side port. I like cruising at high altitude.
But yes I would use the Racing Beat housings or build my own. Simple
if you don't try to put butterflies in the housing. Mazda Speed sells
Mazda P-port housings but I think the hole is smaller.
The diameter of the tubing for the P-port is 2 inch OD with .065 wall mainly because
that is all you can get in 180 degree bends. You don't really need the .065
wall. 0.035 wall would be better if you can find some bends in that size tubing.
About the same as the Lemans engine. They probably used 50 MM.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.