Subject: Low cost slide throttle for P-ports
From: ACRE
Date: 2/16/2005, 8:39 PM


     > This can be made with just a sheet metal shear and a brake.
     > The slide uses six small off the shelf ball bearings and shoulder
     > bolts from Stock Drive Products. Can be made from steel or aluminum.
     > The slide will work best when made from .065 steel as it is stiffer
     > than aluminum. The inner and outer sheet metal parts can then be made from
     > .065 T3 aluminum sheet.
     >
     > My guess this is worth 10 to 15 HP more over using
     > butterflies with P-ports.
     >
     > If anybody is interested I will do a 2D dwg with dimensions.
     >
     > Paul Lamar
     >

         Paul



         I would like to see a 2D and dimensions !



        Kelly Troyer

OK Kelly. Will work on a 2D. I will also reverse it so throttle in
is full throttle and throttle out is closed with a simple push
pull control cable for a tractor airplane. You pusher guys might 
want to use it as is.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.