Subject: Low cost slide throttle for P-ports
From: ACRE
Date: 2/18/2005, 12:41 PM


It occurred to me that this slide throttle is both cheaper and easier to
make
than butterfly throttle bodies. Small ball bearings are about $4 each from
McMaster Carr, shoulder screws are as little as 72 cents each if bought
ten at a time.
A butterfly throttle body requires shafts with expensive machining. If
bought
new a single large throttle body can cost over $200. If made ten at a time
or more these low cost slide throttle sheet metal parts can be very cheap
indeed.
I know of a shop in Torrance California (Talins) that can hold very tight
sheet
metal tolerance with computer controlled shears, punches and press
brakes. If we get ten or more people interested I will get a quote
from Talins.

Here is a area comparison of butterfly throttle body sizes with runner
sizes done
by Rino Lacombe awhile back. Two P-port 2 inch OD runners with .065 wall
would have
an ID of 1.875 and an area of 2.76 square inches each for a total area of
5.52 square
inches. Actually less than the total area of an 1988 13B turbo four port.
Apparently the excellent flow coefficient of the P-port really pays
off despite having less total area.

I also checked the clearance of the this slide throttle with the water
pump. Looks like I lucked out. It will work :).

Paul Lamar

Paul;
I think this is an excellent refinement.
An idea for you to contemplate...   make one slide throttle per runner.

This will get volume up, possably reducing cost per.

1-4 rotor builders can use the same part.


 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.