> It occurred to me that this slide throttle is both cheaper and easier to make
> than butterfly throttle bodies. Small ball bearings are about $4 each from
> McMaster Carr, shoulder screws are as little as 72 cents each if bought ten at a
> time.
> A butterfly throttle body requires shafts with expensive machining. If bought
> new a single large throttle body can cost over $200. If made ten at a time
> or more these low cost slide throttle sheet metal parts can be very cheap
> indeed.
> I know of a shop in Torrance California (Talins) that can hold very tight sheet
> metal tolerance with computer controlled shears, punches and press
> brakes. If we get ten or more people interested I will get a quote
> from Talins.
> Paul Lamar
Paul ,
Put me on your list of the "Very" interested
Kelly Troyer
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.