It occurred to me that this slide throttle is both cheaper and easier to make
than butterfly throttle bodies. Small ball bearings are about $4 each from
McMaster Carr, shoulder screws are as little as 72 cents each if bought ten at a time.
A butterfly throttle body requires shafts with expensive machining. If bought
new a single large throttle body can cost over $200. If made ten at a time
or more these low cost slide throttle sheet metal parts can be very cheap indeed.
I know of a shop in Torrance California (Talins) that can hold very tight sheet
metal tolerance with computer controlled shears, punches and press
brakes. If we get ten or more people interested I will get a quote
from Talins.
Here is a area comparison of butterfly throttle body sizes with runner sizes done
by Rino Lacombe awhile back. Two P-port 2 inch OD runners with .065 wall would have
an ID of 1.875 and an area of 2.76 square inches each for a total area of 5.52 square
inches. Actually less than the total area of an 1988 13B turbo four port.
Apparently the excellent flow coefficient of the P-port really pays
off despite having less total area.
I also checked the clearance of the this slide throttle with the water
pump. Looks like I lucked out. It will work :).
Paul Lamar
I'd be interested in a quote.
Barry Gardner
Wheaton, IL
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.