Here are the dimensions. I changed the design to make the clearances
adjustable. When you bolt it together you can adjust the clearance so the
center slide moves back and fourth freely. It also lowered the height an
inch or two giving more clearance from the exhaust manifold.
Bend up the lenght of the sheet metal according what what you need. One
two or three rotors. Will work with side ports if you space the runners on
approximately three inch center lines. You will need four smaller holes in
the slide instead of two of course.
Paul Lamar
Paul,
Have you had enough interest to obtain a quote ?
Kelly Troyer.
Not so far.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.