> It occurred to me that this slide throttle is both cheaper and

easier to make

     > than butterfly throttle bodies. Small ball bearings are about

$4 each from

     > McMaster Carr, shoulder screws are as little as 72 cents each

if bought ten at a

     > time.
     > A butterfly throttle body requires shafts with expensive

machining. If bought

     > new a single large throttle body can cost over $200. If made

ten at a time

     > or more these low cost slide throttle sheet metal parts can be

very cheap

     > indeed.
     > I know of a shop in Torrance California (Talins) that can hold

very tight sheet

     > metal tolerance with computer controlled shears, punches and

press

     > brakes. If we get ten or more people interested I will get a

quote

     > from Talins.
     > Paul Lamar

         Paul ,

           Put me on your list of the "Very" interested



        Kelly Troyer

"Barry A. Doublestein" wrote:

Paul,

I am interested as well.

Barry Doublestein

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.