Hi! Paul
A few questions, Can you tell me where to get information on machining P-ports in rotor housing. Put me on the list for the slide throttle. I'm also looking for a supplier for intake "U" bends. My
engine came with a plastic thermostat cover (broken) is there an aluminium cover available (91 13b NA). Is it possible to use a smog pump as a vacuum source for instruments with a regulator?
Regards.
Georges & Gail Boucher
2126 Creighton Valley Road
Lumby, British Columbia
Canada  V0E 2G1
(250) 547-6434
www.echolakefishingresort.com
www.echolakefishingresort.ca

I am not sure Jerry Hey still wants to do that. You can buy them from Racing
Beat in Anaheim CA. It is also pretty easy to do on your own as they are
just 2 inch holes with short pieces (3 or 4 inches) of two inch tubing epoxies in.
High temp epoxy work fine if you groove the out side of the tubing a tiny
bit. If you want you can cut 2.5 or 3 inch thick wall tubing on a lathe leaving a
bit of flange to screw the slide throttle to using 6-32 flat head screws. Scale this drawing for the proper position  of the 2 inch holes in the rotor housing.

Paul Lamar

Georges, here is one way of attaching the slide throttle to the p-port.


Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.